Clutch Cable Replacement Ninja. helping the sis replace the clutch cable on a 2009 kawasaki ninja 250r.3/17 update: kawasaki ninja 250r clutch cable replacement. 1) use the adjusting screw on the bottom of the cable (the end attached to the engine) to give you as much slack in. Screw driver, 8mm socket, 5mm allen key and 4mm allen. Then pull the new cable into the housing, making sure the lower nut is loose by the. This is why it is not disengaging. the cable is adjusted by checking the amount of freeplay at the clutch lever. it sounds to me like they have adjusted your clutch incorrectly and you now have too much free play in the cable. Now finish routing the new cable in place of the old cable. remove the old cable end from the clutch lever clevis and pull out of the housing. here is me installing a new one!. hook the new cable end into the clutch lever. Free play is the amount that the lever moves before it actually starts putting.
helping the sis replace the clutch cable on a 2009 kawasaki ninja 250r.3/17 update: it sounds to me like they have adjusted your clutch incorrectly and you now have too much free play in the cable. the cable is adjusted by checking the amount of freeplay at the clutch lever. This is why it is not disengaging. Now finish routing the new cable in place of the old cable. Then pull the new cable into the housing, making sure the lower nut is loose by the. kawasaki ninja 250r clutch cable replacement. 1) use the adjusting screw on the bottom of the cable (the end attached to the engine) to give you as much slack in. remove the old cable end from the clutch lever clevis and pull out of the housing. here is me installing a new one!.
Clutch Cable Replacement Ninja the cable is adjusted by checking the amount of freeplay at the clutch lever. kawasaki ninja 250r clutch cable replacement. the cable is adjusted by checking the amount of freeplay at the clutch lever. Then pull the new cable into the housing, making sure the lower nut is loose by the. helping the sis replace the clutch cable on a 2009 kawasaki ninja 250r.3/17 update: 1) use the adjusting screw on the bottom of the cable (the end attached to the engine) to give you as much slack in. it sounds to me like they have adjusted your clutch incorrectly and you now have too much free play in the cable. Screw driver, 8mm socket, 5mm allen key and 4mm allen. Free play is the amount that the lever moves before it actually starts putting. here is me installing a new one!. remove the old cable end from the clutch lever clevis and pull out of the housing. hook the new cable end into the clutch lever. This is why it is not disengaging. Now finish routing the new cable in place of the old cable.